1941
CS-Lab / Re: incremental encoder 10.000 RPM
« on: January 08, 2015, 07:20:56 PM »
Afraid not, the CS-Lab products use full encoder for lathe threading and it needs to be 1:1.
On the small lathe I had a servo motor geared 2:1 and I used the motors encoder for feedback to the Enc module, I however scaled the encoder output in the drive so that there was still one Index per rev.
Hood
On the small lathe I had a servo motor geared 2:1 and I used the motors encoder for feedback to the Enc module, I however scaled the encoder output in the drive so that there was still one Index per rev.
Hood