1
General Mach Discussion / can any one help me to config mach3
« on: October 23, 2018, 07:46:14 PM »
Hello to all and sorry for my bad english
So here is the problem
I have a desktop mill and I had to open the control box to check the spindle inverter and i found that there is a spindle conection on my control board
I have not been able to config mach3 to activate the spindle output
I am using the rnr eco motion pulgin to ake the machine move
thanks for your help
So here is the problem
I have a desktop mill and I had to open the control box to check the spindle inverter and i found that there is a spindle conection on my control board
I have not been able to config mach3 to activate the spindle output
I am using the rnr eco motion pulgin to ake the machine move
thanks for your help