4531
General Mach Discussion / Re: Mach 3 Laser config
« on: November 13, 2014, 12:24:20 PM »
Hi Hydrops,
Basically, if your Gcode does not contain any Z axis moves then the Z axis should not move – simple as that really.
Perhaps use a text editor with ‘search and replace’ to delete any Z axis commands from your Gcode??
If you attach a picture, or two, of the excessive burn near the edges of the drawing this may give us a better understanding of the cause of the problem.
Tweakie.
Basically, if your Gcode does not contain any Z axis moves then the Z axis should not move – simple as that really.
Perhaps use a text editor with ‘search and replace’ to delete any Z axis commands from your Gcode??
If you attach a picture, or two, of the excessive burn near the edges of the drawing this may give us a better understanding of the cause of the problem.
Tweakie.