7861
General Mach Discussion / Re: Acu-rite Glass Scale Position-Trac Coding
« on: September 23, 2010, 12:00:28 PM »
Right - I see what you are trying to achieve now.
As far as I am aware Mach does not operate in closed loop mode.
With servo systems the feedback loop is closed within the servo driver and errors corrected at that point rather than within Mach itself.
This does not mean to say that Mach cannot be operated in closed loop mode but you might just have to be the first person to do it
Good luck,
Tweakie.
As far as I am aware Mach does not operate in closed loop mode.
With servo systems the feedback loop is closed within the servo driver and errors corrected at that point rather than within Mach itself.
This does not mean to say that Mach cannot be operated in closed loop mode but you might just have to be the first person to do it
Good luck,
Tweakie.