This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Filename | Downloads | Message | Posted |
---|---|---|---|
GW_Circle_Cut.jpg | 889 | Re: cut circle wizard by Kiran problem | June 25, 2007, 05:12:50 AM |
GW__2007-12-31_14.02.jpg | 524 | Re: crank shaft | December 31, 2007, 08:55:11 AM |
Crank-op-1.tap | 199 | Re: crank shaft | December 31, 2007, 08:55:11 AM |
GW__2007-12-31_14.09.jpg | 494 | Re: crank shaft | December 31, 2007, 08:55:11 AM |
GW__2007-12-31_14.15.jpg | 515 | Re: crank shaft | December 31, 2007, 08:55:11 AM |
Sunglass1.jpg | 818 | Re: converting *.Mc9 to Mach3 G-code | November 14, 2006, 02:54:07 PM |
glasses2.JPG | 747 | Re: converting *.Mc9 to Mach3 G-code | November 15, 2006, 07:07:28 AM |
sphere1.jpg | 755 | Re: converting *.Mc9 to Mach3 G-code | November 16, 2006, 05:12:10 AM |
IMG_20190621_211523444.jpg | 370 | Re: Coming soon to a lathe near you | June 18, 2019, 09:03:12 AM |
IMG_20190621_211411571.jpg | 357 | Re: Coming soon to a lathe near you | June 18, 2019, 09:03:12 AM |