Messages

1461

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 11:18:08 AM »

try to Win Start - run - systeminformation (hope it is simular in the english Version)

1462

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 11:06:10 AM »

can't run drivertest here (64Bit), is there any port adresss shown?

1463

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 11:02:24 AM »

but you said, you run drivertest succesfuly?

1464

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:50:24 AM »

sorry have only a german version

1465

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:34:25 AM »

just to confirm:

-Settings -> Port's&Pin's -> Port Setup and axis selection -> Port 1 is enabled
-Settings -> Port's&Pin's -> Port Setup and axis selection -> Port 1 adress is set correctly
-Settings -> Port's&Pin's -> Motor Outputs -> axis is enabled
-Settings -> Port's&Pin's -> Motor Outputs -> Step Pin , Dir Pin and port are correct

1466

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:29:45 AM »

i assume you are using the Standard 1024 sceenset.

is the reset button permanent green or flashing ?

1467

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:26:08 AM »

btw are your axis dro's changing if you try to jog?

1468

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:23:26 AM »

due searching for a Manual for your breakout bord, there seam to be different Versions.

do you have this Version, with the jumper's,
and are both jumper's set ?

1469

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 10:03:35 AM »

see attached

1470

General Mach Discussion / Re: Newbie to cnc building in need of some help please

« on: January 20, 2019, 09:51:40 AM »

I have
   red=a+
green=a-
 black=B+
  blue=B-

i have been using this:

https://de.aliexpress.com/item/Stepper-Motor-4AXIS-Nema-23-425oz-in-23HS9430B-3A-dual-shaft-DM542A-Stepper-Driver-CNC-Router/32620908893.html

as wiring reference

this also say's enabl+ Needs to be connected