17951
General Mach Discussion / Re: Gcode/post processor help G77
« on: September 17, 2009, 06:49:43 PM »
If you have installed mach to the default location it will be in C:\Mach3\Macros\Mach3Turn
If you have a custom profile then there is a chance you didn't clone it from a turn profile and if thats the case then you will not have these macros there, just copy them over from the Turn folder.
Hood
If you have a custom profile then there is a chance you didn't clone it from a turn profile and if thats the case then you will not have these macros there, just copy them over from the Turn folder.
Hood