1611
Works in progress / Re: New 4 Axis Milling Screen Set (RaspScreen)
« on: January 04, 2009, 08:25:56 PM »
I think you're doing a beautiful job, Graham, it's a very different but great look-
Dave
Dave
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I use a recoil usb gamepad I picked up at Walmart for $12.00 I think it was. It works great but I don't feel comfortable leaving the machine up for extended periods with it hooked up. Sometimes it will creep in an axis and has cost me a few endmills . It has to do with the centering of the axis sticks and a slight temperature change can take them off center.
Brett