16081
General Mach Discussion / Re: Mach 3 stopped working
« on: March 23, 2010, 05:31:31 PM »
Philip, afraid that one is blank as well.
You will need to find out which pins you have the Step and Dir signals connected to and set them up in Ports and Pins, Motor Ouputs, and also remember to enable each axis and set a port number for each step and dir pin.
Your port number will just be 1 unless you have a second port, so that part should be straightforward.
Hood
You will need to find out which pins you have the Step and Dir signals connected to and set them up in Ports and Pins, Motor Ouputs, and also remember to enable each axis and set a port number for each step and dir pin.
Your port number will just be 1 unless you have a second port, so that part should be straightforward.
Hood