1
General Mach Discussion / Hole milling problem
« on: November 01, 2023, 05:22:50 AM »
Hi, I'm new to the forum and would like to help with the problem.
I use Mach3 software.
The problem is when I make a hole in the milling material, diameter 18 mm. The router makes a 21.5 mm hole. Is there any scaling in the Mach3 program that affects it. If so, how to remove it
I use Mach3 software.
The problem is when I make a hole in the milling material, diameter 18 mm. The router makes a 21.5 mm hole. Is there any scaling in the Mach3 program that affects it. If so, how to remove it