11071
General Mach Discussion / Re: Breakout Board
« on: August 01, 2011, 03:52:31 AM »
Yes it would be the machine side of the BOB that would be 24v or configurable if possible. Dont know enough about electronics, in fact I know Sweet FA But the drives I use can have the I/O in them set between 10 and 30v and what voltage that will be is determined by the voltage you supply to the I/O power terminals. That would definitely be a nice feature to have if possible as hopefully more will see the advantage of using the higher voltages for machine side I/O
But as said personally I will be unlikely to buy another BOB as the external controllers I, more than likely, will use in the future already have 24v I/O and dedicated 5v for Step/Dir.
Hood
But as said personally I will be unlikely to buy another BOB as the external controllers I, more than likely, will use in the future already have 24v I/O and dedicated 5v for Step/Dir.
Hood