16681
General Mach Discussion / Re: Saving Tool Table...
« on: January 30, 2010, 04:35:42 PM »
Well if I dont click apply I get asked if I want to save the table when I shut Mach down, but again this is turn so not sure about Mill.
Couple of things you could try, first is check the Tools3.dat is not read only and if its not then maybe at the end of your macro have DoMenu(1,14)
Hood
Couple of things you could try, first is check the Tools3.dat is not read only and if its not then maybe at the end of your macro have DoMenu(1,14)
Hood