1
General Mach Discussion / Re: Why does it follow different tool paths from G code preview?
« on: November 29, 2018, 06:27:02 PM »
garyhlucas and Tweakie.CNC thank you very much for your early advice.
I will check with a more simple code.
Then, without believing the code automatically generated by Fusion 360, I will try to understand the code a little more and try upgrading the MACH 3.
However, sometimes it worked well when tested with the same code, is this also a common bug phenomenon?
I will check with a more simple code.
Then, without believing the code automatically generated by Fusion 360, I will try to understand the code a little more and try upgrading the MACH 3.
However, sometimes it worked well when tested with the same code, is this also a common bug phenomenon?