1
General Mach Discussion / Run from here returns to 0,0,0 sometimes
« on: December 30, 2012, 08:18:37 PM »
Occasionally Run from Here will return to 0,0,0 (not in the code, just moves to the origin; the DRO shows it; the Code Window holds on the line it's supposed to be going to) then return to the line selected, then continue on.
Doing a feed hold, then full stop.
Rewind to beginning
using go to line number to select the line
hitting run from here
then letting it go to the Preparation Positioning
I've done this exact sequence about 50 times, and about 10 times it returned to zero; the other times it ran as expected.
I've been running hundreds of jobs with previous versions over 10 years; this only happens with the latest stable version; R3.043.066 I installed today.
Was using 1.84 for years; the past year or so running 2.48. I recall versions previous to 1.84 doing this.
Any idea what I'm doing wrong? Or is this a known issue?
Doing a feed hold, then full stop.
Rewind to beginning
using go to line number to select the line
hitting run from here
then letting it go to the Preparation Positioning
I've done this exact sequence about 50 times, and about 10 times it returned to zero; the other times it ran as expected.
I've been running hundreds of jobs with previous versions over 10 years; this only happens with the latest stable version; R3.043.066 I installed today.
Was using 1.84 for years; the past year or so running 2.48. I recall versions previous to 1.84 doing this.
Any idea what I'm doing wrong? Or is this a known issue?