2411
General Mach Discussion / Re: Slaved stepper not moving the same amount???
« on: August 02, 2014, 03:49:50 PM »
Yes, just changing the pin assignment in Mach will be fine for this test.
If the problem still happens with the same motor then it is likely there is an issue with the breakout board or possibly the drive if you have not tried swapping them.
If the problem shifts to the other motor then it seems likely there is a problem with the output from Mach as Mach will now be seeing that motor as the slave.
Hood
If the problem still happens with the same motor then it is likely there is an issue with the breakout board or possibly the drive if you have not tried swapping them.
If the problem shifts to the other motor then it seems likely there is a problem with the output from Mach as Mach will now be seeing that motor as the slave.
Hood