Having an issue with the SS when I try to start Mach. (This config file works great in Parallel Mode)
When I start it up, I select the SmoothStepper_v17d as the external motion controller.
This is the next screen I see after clicking ok
If I click "yes" for default values, it wipes out all of my port and pins settings, but will allow Mach to communicate with the SS with no issues (other than nothing is setup and all my settings are gone).
If I click No and run the SS configuration and input all of my values in there and then click ok, I get this
Any suggestions on what I am missing? I have also sent a message to Warp9TD, hoping to get this up and running soon.....
I have Mach3 R3.043.022 as well as SS 17d plugin