4331
Mach4 General Discussion / Re: mach 4 demo setup and try.
« on: June 11, 2018, 02:53:47 PM »
Hi,
download the UC100 Mach4 plugin from the CNCDrive website. Put the plugin and its .sig file in the Mach4 Plugins folder.
Enable the plugin in Configure/Control/Plugins and restart Mach. Select the plugin as active motion controller in Configure/Control/Select Motion Device.
You can now populate the plugin with your pin assignments. I use an ESS so I can't help you much there.
Craig
download the UC100 Mach4 plugin from the CNCDrive website. Put the plugin and its .sig file in the Mach4 Plugins folder.
Enable the plugin in Configure/Control/Plugins and restart Mach. Select the plugin as active motion controller in Configure/Control/Select Motion Device.
You can now populate the plugin with your pin assignments. I use an ESS so I can't help you much there.
Craig