Good day.
When I cut with my router ...and after it has finished the router will go to x0 y0 that has been set.
and the lift the Z 0.8" the bit height from the work.

I would like for the plasma to behave the same...
between cuts it will lift at a set height that I put in Mach4 (Avid) but at the end of the cut it will go x0 y0
Parking set in sheetcam but the Z will lift all the way up.

Anyone know where I need to set the value?

Thank you!

Nevermind sheetcam has an option in the postprocessor at add distance.