Messages

1021

General Mach Discussion / Re: Mach3 scaling issue

« on: February 28, 2020, 02:57:28 AM »

can you pls post your g-code?

1022

General Mach Discussion / Re: pwm spindle control help needed

« on: February 28, 2020, 02:56:20 AM »

so it Looks like the bob is not able to deliver the current for the analog Input of the VFD witch is very unusual.

the wiring is like in the Manual?

1023

General Mach Discussion / Re: Mach3 freezes afterloading g-code/toolpath graphics

« on: February 28, 2020, 02:44:37 AM »

try to use 043.62 or even 043.22 witch is recomended by CSLAB.

patched 043.62: https://www.machsupport.com/wp-content/uploads/2013/04/Mach3Version3.043.exe

043.22: ftp://anonymous:guest@ftp.machsupport.com/Mach3/Mach3Version3.043.022.exe

1024

General Mach Discussion / Re: Mach3 freezes afterloading g-code/toolpath graphics

« on: February 27, 2020, 04:00:56 AM »

witch Version of Mach3 are you using?

1025

General Mach Discussion / Re: pwm spindle control help needed

« on: February 27, 2020, 03:48:48 AM »

had a quick look to the Manual of the breakout board.
i think you are using this board: https://www.cnc4you.co.uk/Breakout-Board-and-PSU's/Breakout-board-CP0-10V-CNC-4-Axis-with-Charge-Pump

Manual says, supply for the board should 24V-48V. are you using Minimum 24VDC Power supply?

1026

General Mach Discussion / Re: pwm spindle control help needed

« on: February 26, 2020, 06:08:42 AM »

have you checked the 0-10V with VDF disconnected

1027

General Mach Discussion / Re: How to connect my KX3S to PC via Ethernet?

« on: February 26, 2020, 02:25:22 AM »

have you tryed to contact Sieg? without knowing witch Motion Controller is installed, it will be nearly impossible to find the correct plugin for it.

1028

FAQs / Re: Homing/limit switches- type No or NC? Not working on my CNC Router

« on: February 24, 2020, 03:05:35 AM »

the safest way would be to Switch a external relay with the proximity Switch and then use a contact of the
relay to Switch the Input of the bob.

1029

VB and the development of wizards / Re: How to create a simple toggle button?

« on: February 20, 2020, 01:31:37 AM »

should be

SetOutBit(BuffIndex, BitNumber)
ReSetOutBit(BuffIndex, BitNumber)

but never worked with modbus

1030

FAQs / Re: Homing/limit switches- type No or NC? Not working on my CNC Router

« on: February 19, 2020, 12:25:08 PM »

give this a try:

https://www.machsupport.com/wp-content/uploads/2013/02/Mach3Mill_Install_Config.pdf

chapter 4.5 there is normaly every answer you are looking for.