Messages

31

General Mach Discussion / bitsensor usb controller

« on: December 12, 2018, 01:30:15 PM »

Hi just bought one of these off ebay, everything on the CD is in Chinese, can anyone point me to an english manual or set up instructions? ive got as far as loading the plugin and it isnt throwing up any errors. ive connected it within mach3 and the plugin control is there so im assuming so far so good. however not sure how to set up the ports? ive set up uc300's and smooth steppers so im not a novice!!

Regards
  Tony

32

General Mach Discussion / Re: anilam 3000 retro fit?

« on: March 04, 2018, 06:00:26 AM »

drive number sma7215-200-1 revb I cant find in any specs or a manual?

33

General Mach Discussion / Re: anilam 3000 retro fit?

« on: March 03, 2018, 04:05:04 PM »

Hmm at £600 its not a cheap option, would be cheaper to buy new drives .

34

General Mach Discussion / anilam 3000 retro fit?

« on: March 03, 2018, 08:23:47 AM »

I have a retrofit to do on an anilam 3000 controlled machine.
the drives and motors are fine ,but I believe the system is 0-10v.
what are the options of interfacing to mach3?
if possible id like to use a uc300 as the primary motion controller but thats not set in stone.

   Regards
   Tony

35

General Mach Discussion / DRO refresh rate

« on: March 01, 2018, 04:21:12 AM »

Hi does anyone know what the dro refresh rate is?
also is it possible to adjust it, what controls it?

Regards
  Tony

36

General Mach Discussion / Re: I Need a macro written will pay.

« on: February 24, 2018, 12:41:36 PM »

Can I just give a massive public thankyou to Thomas for his help in getting this project up and running,thank you. what a gent !

Tony

37

General Mach Discussion / Re: I Need a macro written will pay.

« on: February 12, 2018, 06:24:10 AM »

Thanks Thomas,
  looking forward to getting it together.
  Tony

38

General Mach Discussion / Re: I Need a macro written will pay.

« on: February 12, 2018, 06:06:33 AM »

  Yes I just need to check the wiring of the laser to amp and verify its output, I have already allocated a input.
can you explain
The top left figures (laser parameters) and how to use /set them?

  Regards
   Tony Horton

39

General Mach Discussion / Re: I Need a macro written will pay.

« on: February 12, 2018, 04:54:03 AM »

Got it --I think!
I have made the macropump.m1s in vb editor, there is just your code in that file, or should there be other code?

Tony

40

General Mach Discussion / Re: I Need a macro written will pay.

« on: February 12, 2018, 04:51:43 AM »

Got it --I think!
I have made the macropump.m1s in vb editor, there is just your code in that file, or should there be other code?

Tony