7451
General Mach Discussion / Re: Mach3 probe problem
« on: February 23, 2011, 05:34:52 AM »
Just a guess but if the Z axis DRO has not been zeroed (suppose it reads 50.0000) then the Z axis will go down to get to 5.0000 (or whatever your touch off standard distance is) rather than up.
Unless your probing routine takes care of the G90 / G91 then yes it will make a difference.
As Hood suggested post your VB and check that you have everything set correctly in the screen set.
Tweakie.
Unless your probing routine takes care of the G90 / G91 then yes it will make a difference.
As Hood suggested post your VB and check that you have everything set correctly in the screen set.
Tweakie.