Messages

2971

General Mach Discussion / Re: Missing Steps

« on: May 18, 2006, 07:12:15 AM »

Very Good! No you can't do anything to hurt a stepper  Other than taking a hammer to it I think you are safe

Happy cutting

2972

General Mach Discussion / Re: Planning my first cutting project

« on: May 18, 2006, 07:08:58 AM »

At this point I would draw the 4 parts and have Lcam make the program. There are ways to make the Gcode cut the same part with an offset... But I find that to be a little slower because I have to hand code part of the program.

Hope that helps
Brian

2973

General Mach Discussion / Re: PLC capabilities

« on: May 18, 2006, 07:03:03 AM »

If you getto somthing that you can't do just post it and we will see what we can do

2974

LazyCam (Beta) / Re: Lazy CAM problem

« on: May 17, 2006, 10:29:53 PM »

There are many new bugs in this version of the free cam software with mach3... We are working on the problems and after the workshop we will push to fix your problems...

2975

General Mach Discussion / Re: Missing Steps

« on: May 17, 2006, 10:07:11 PM »

If there is anything that I can do to help   I am here

2976

General Mach Discussion / Re: I/O

« on: May 17, 2006, 10:01:43 PM »

The only other thing is the G100 from GeckoDrive.com . This is run by Mach4 and should be released in a few months...

2977

General Mach Discussion / Re: Tool offsets table

« on: May 17, 2006, 09:59:55 PM »

No not at this time

2978

General Mach Discussion / Re: retrofiting dyna 2800

« on: May 17, 2006, 09:58:34 PM »

I think what you are hearing is the steppers at slow speed.. try jogging the mill at low speeds.

2979

General Mach Discussion / Re: PLC capabilities

« on: May 17, 2006, 09:52:55 PM »

The VB is what we use to do this.... IT is not ladder logic but...

2980

General Mach Discussion / Re: Homeing All Axis not working properly

« on: May 17, 2006, 09:51:18 PM »

The noise is from other wires in your system... If you have power wires running along side the logic wires you can pick up noise...