2341
General Mach Discussion / Re: Manual Z offset while program is running
« on: September 06, 2014, 05:33:06 PM »
You could MDI a G52 (temporary offset) but not while the code is actually running.
The other option is just to type a different value into the Z DRO before you run the code again. For example if you do your rough and find that you still have to remove 1mm for your finished size, then you would just add 1mm to the Z DRO and run the code again.
Hood
The other option is just to type a different value into the Z DRO before you run the code again. For example if you do your rough and find that you still have to remove 1mm for your finished size, then you would just add 1mm to the Z DRO and run the code again.
Hood