16771
General Mach Discussion / Re: changing out bits but keeping bit length...
« on: January 25, 2010, 03:39:16 PM »
When I was talking about collet holders I was meaning like a milling machine would use, for example a 40taper ER32 holder. From what I think you are saying is your spindle is the collet holder, if so then probably your only real option would be to have collars fixed to the tools so they can only be put so far into the collet and thus you can repeatably place each tool even if they are different lengths and you can set them up in the tooltable.
Hood
Hood