4581
General Mach Discussion / Re: program pause until spindle starts
« on: February 27, 2012, 02:06:15 PM »
I thin what Gerry is asking IS do you have the spindle setup in MACH3 config. IF not then Mach may ignore ANY m3 it sees. SO if you put your code in the M3 macro Mach3 will never see it.
You could build a simple Mcode (M100) that contains the code then place the M100 where a M3 would go. THAT will test your funtion.
Just a thought, (;-) TP
You could build a simple Mcode (M100) that contains the code then place the M100 where a M3 would go. THAT will test your funtion.
Just a thought, (;-) TP