OK got the machine to move, figured out 64 bit Win 7 doesnt work, so loaded 7 32 bit. Now jusy have to figure out the pin for the laser. I have 1 and 1 set with the active low set, i keep the laser off when I start the software, but it doesnt turn it off when i run . so still need to work on that.
This is the board im running, my output is the last two screws on right side of output. Pins 2,3,4,5,6,7,14,15,16,17, are used for the steppers.
https://www.probotix.com/wiki/index.php/PBX-RF