416
« on: February 04, 2022, 10:36:35 AM »
When you say "the motors" run, how are you making them - by jogging or how? If by jogging at least the basic system is operating.
What are "I/O" figures? Are these the settings in the config boxes (ports&pins, motor tuning, etc)? What is an I/O figure of 0?
Where are you looking for a waveform on a driver test? You say that this is a "USB" router which implies that it doesn't use a parallel port, in which case the driver test is irrelevant since it just tests the ability of the PC to generate pulses fast enough to drive the steppers. There are software plug-ins to manage the pulse interface - parallel port, USB motion controller etc - and if you select config->plugins there probably isn't one for a PP but should be one for a USB device. If the PP one does show it should not be ticked, the USB one should be.
What is in the "6090" zip? If it contains something which looks like "6090.xml" that would be a configuration file that has all the pin assignments etc and if you copy it into the mach3 folder it should set up the controller for you.