Messages

1411

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 01:16:53 AM »

do you have torque at the motorshaft if you only turn on the supply voltage?

can you post:

-the dip Switch Settings of the DQ542MA ?
-a screenshot of the Motor Tuning page from the x-axis ?

1412

General Mach Discussion / Re: DQ542MA

« on: February 09, 2019, 11:54:56 AM »

just check with a Voltmeter on EN+ and EN- for 5v

1413

General Mach Discussion / Re: DQ542MA

« on: February 09, 2019, 03:37:12 AM »

had a look to the Manuals:

-HY-DIV268N
EN +: offline can reset signal input side is
EN-: offline can reset signal input negative terminal
Offline enable signal is active, reset drive failure to prohibit any pulse, the output of the drive Power component is turned off, the motor holding torque.

-DQ542MA
ENBL+ is the positive end of direction input pin. This signal is used for
enabling/disabling the driver. High level for enabling the driver and low level for disabling the driver.
ENBL- is the negative end of direction input pin. Usually left unconnected (enabled)


so it Looks like the enable signals are oposite.

check enable on the DQ542MA to be high if you want run the motor

1414

General Mach Discussion / Re: Mach3 Breakout Board Inputs

« on: February 07, 2019, 10:38:48 AM »

have you tryed to connect to an other pin (10/11)?

1415

General Mach Discussion / Re: where are the wizards kept?

« on: February 06, 2019, 04:48:09 AM »

not sure, but maybe there:

https://www.machsupport.com/forum/index.php/topic,20001.msg138532.html#msg138532

is what you are looking for.

1416

Mach Screens / Re: Probe

« on: February 05, 2019, 11:05:14 AM »

try to copy the code from machsreen Editor to an other Editor like Notepad++, just to see that there is a correct CRLF at the
end of each line.

1417

VB and the development of wizards / Re: Enable multiple LEDS

« on: February 05, 2019, 10:32:26 AM »

not in one instruction

1418

General Mach Discussion / Re: where are the wizards kept?

« on: February 05, 2019, 10:30:00 AM »

C:\Mach3\Addons and then a Folder for each Wizard.

1419

German / Re: hotkey foam cutter

« on: February 05, 2019, 03:42:16 AM »

Hallo,

diese Nummern sind nicht in der Auswahlliste für die OEM Buttons aufgeführt, einfach die Zahl reinschreiben.

1420

German / Re: hotkey foam cutter

« on: February 04, 2019, 02:34:36 AM »

Hallo,
hier http://www.machsupport.com/forum/index.php/topic,8211.0.html
ist ein bischen was und auf der Newfangled Hompage gibt's noch ein
Video.

Das war es aber meines Wissens nach schon.

Ja der Editor ist schlecht/schwer zu Bedienen, aber wenn man ein Weile rumspielt wird das schon.

Gruß Tom