16891
General Mach Discussion / Re: A Lathe Question For Hood
« on: January 15, 2010, 01:22:07 PM »
At the moment you need to have all tools designated the same, either all front or all rear so you would if using in the front post either use the G51X-2 and code positive values for the X or code negative values with no X scaling in effect..
In the future you will be able to designate front/rear and what that will hopefully do is autoswap the X axis direction so that all coding will be positive values unless you specifically want and write them as negative values.
Hood
In the future you will be able to designate front/rear and what that will hopefully do is autoswap the X axis direction so that all coding will be positive values unless you specifically want and write them as negative values.
Hood