15011
General Mach Discussion / Re: Spindle DRO not working in Mach3 Turn
« on: August 24, 2010, 11:31:33 AM »
Just looked again and see you have an index debounce of 100, set that to zero and it may help.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Also that there will soon be a revision of Mach3 for us lowly 2 axis folk, do you have any idea when that might be?
Regards,
John.