2481
General Mach Discussion / Re: Can not seem to carve out a simple box ?
« on: September 27, 2017, 02:07:55 AM »
Looks like the G-Simple website has been hacked so forget about that one.
If you are using an unlicensed version of Mach3 (Demo Mode) then it will only run the first 500 lines of Gcode and may not complete your engraving job. Purchasing a license removes this restriction http://www.machsupport.com/shop/mach3/
Tweakie.
If you are using an unlicensed version of Mach3 (Demo Mode) then it will only run the first 500 lines of Gcode and may not complete your engraving job. Purchasing a license removes this restriction http://www.machsupport.com/shop/mach3/
Tweakie.