9881
General Mach Discussion / Re: re : Mach turn ,tool radius index too big
« on: December 28, 2011, 05:00:54 PM »
The G76 is nothing like what is needed for Mach, not sure whats what in it but shouldnt be an F and shouldnt be a U. As said the spring pass (Q) is 60 so not sure what they are putting in there if its only meant to be one. Did you tell the CAM it was an infeed of 60 degrees? maybe thats what it is, BTW 29.5 would be a normal infeed value to use.
Hood
Hood