3881
General Mach Discussion / Re: Problems with Mach3 , Gcode or BobCad! and I am not sure whats going on!!
« on: November 09, 2013, 06:14:25 AM »
Ok so if you jog positive (numbers in DRO go positive) is the tool moving to the right in relation to the work (table moving left) ?
If it is then that means Mach is seeing the direction as it should and it is just your method is a bit different from standard.
If you let me know if the above is correct then I can tell you how to set up to standard method, just dont want to confuse the situation at the moment.
Hood
If it is then that means Mach is seeing the direction as it should and it is just your method is a bit different from standard.
If you let me know if the above is correct then I can tell you how to set up to standard method, just dont want to confuse the situation at the moment.
Hood