1501
General Mach Discussion / Re: Mach3 on Windows 7 32 bit - Startup Screen always small
« on: May 02, 2019, 05:44:29 AM »
Config. / General Config. check Auto Screen Enlarge box.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
You can even add a cheap "single-relay board" design for Aduino if you want to implement M4 for spindle counterclockwise spin if you use the unused pins (for the unused 5th axis) to drive a Aduino relay board.
The BOB board must be powered by 12-24V otherwise the optically isolated inputs will not work.
USB connection is NOT required
I think it is better to switch the DC side of your spindle.
They really piss me off.....I would still like to see all new members first post be moderated, at least it would give
moderators/administrators an IP address.
Craig
In a matter of minutes in https://www.machsupport.com/forum/index.php?board=11.0 a "shower" of spam
Soo... Captcha SUCKS!
ive been trying to get M11 M10 commands to work with my galil 4133 ethernet controller. for a plasma machine,
will the M10 M11 commands work in mach4 with the new galil plugin.