6781
General Mach Discussion / Re: parrallel pin out and comms with driver board
« on: July 04, 2011, 12:38:16 PM »
Harry,
On the main Mach screen open Config / Ports and Pins. There are tabs for Input Signals and Output Signals - these will show you the available pin numbers and their allocations which you can set as required.
Tweakie.
On the main Mach screen open Config / Ports and Pins. There are tabs for Input Signals and Output Signals - these will show you the available pin numbers and their allocations which you can set as required.
Tweakie.