4221
General Mach Discussion / Re: Problem with Software/Settings ????
« on: June 04, 2011, 03:54:57 PM »
You have your X and Y axis moving backwards. Try going to Config >Homing Limits and check the "Reverse" box for both.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
The difference between the two is that when I open and close something on the notebook it stays steady, when I do it on the controller it takes a blip which doesn't matter though since I'm using a kflop anyway.
Does it force the motor to go to the designated coordinate? does it intergrate with backlash comp? or does it simply identify an error.
I've run the Mach driver test, and it shows no problems.