2961
General Mach Discussion / Re: Can this computer run mach3
« on: February 27, 2017, 02:01:08 AM »
Hi Malcolm,
Assuming you are indeed using the parallel port to drive your CNC machine then you will need to configure the Ports and Pins in Motor Outputs and insure there are no pin number conflicts in Output Signals etc.
This is a screen shot from the last .xml file you posted.
Tweakie.
Assuming you are indeed using the parallel port to drive your CNC machine then you will need to configure the Ports and Pins in Motor Outputs and insure there are no pin number conflicts in Output Signals etc.
This is a screen shot from the last .xml file you posted.
Tweakie.