Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: greenene on April 26, 2015, 11:56:11 AM
-
After installing a different Mach 3 version, my cnc is acting funny regarding two issues.
One, for some reason the numeric keypad no longer works unless I use the MPG window with it. In my previous version, I was able to use the numeric keypad to move the axis. I am not sure what needs to be done...
Two, until the upgrade, I was able to use the "run from here" command and have my job continue. Now, the same command sends the machine axis to the extremes. I am not sure what needs to be set in the config file in order to prevent this from happening.
thanks
tony
-
What version of Mach and what controller are you using. Is the NUMLOCK on or off ??
(;-) TP
-
I am using v 066. Now I have another issue.
In a program with two different tools, when I change to the second tool and hit the "run cycle", the machine goes off the axis.
tony
-
V.066 has issues I would backup to V.062.
(;-) TP
-
This is funny. I had v062 but could not get the M6start to work without a crash. l was told to go to the later version, and now I am having different issues.
I added some code to the M6Start, but the Z axis always wants to move up, past its safe limits and crashes.
I am simply stumped.
tony
-
What code are you running in the M6start I have never had any problem with it. Are you using SafeZ ?
(;-) TP