14651
General Mach Discussion / Re: Referance button
« on: September 22, 2010, 02:17:52 PM »
Seems like you may have a bad screenset as that is the only explanation I can see for both this and your other problem.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I noticed that if the 'Machine Coordinates' button happens to be pressed, strange things happen. I need to find how to determine that button is ON so I can force a warning message.
Thanks again,
Bill
Hood, what IPM do you cut with on your BP?