Hello every body,
I have nearly finished my machine cnc mill, but I have a problem with, I guess the encoders,
Motor:- KL34-180-90
Encoder:- Am 102 Digi-key 500 lines.
Power supply : 65 - 70 volt dc.
Gecko 320x
When I tisted all, motors etc.. with short cables , every thing was ok and motors run very fines. but, when I mounted them on the machine, every thing changed:-
motors do not accelerate very well, that means they take time to accelerate . times of responde is( very long)
and also when they stop, they do stop as before, they contiue to move 1 or 2 seconds.
enocder and motor have long cable, may be more than 5 meters for z and Y..
Could I have your help please?
Thanks a lot
Robhi