5021
General Mach Discussion / Re: Cutting speed
« on: April 30, 2010, 11:47:30 AM »
Depends what you are cutting. We cut wood at 19M/min.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
On linear moves, do you scale each axis independently, or deal with the dominant axis and have tests for the dependant axes on when to take a step? And how do you deal with circular moves
Correct! The "P" Icon should open a page which shows the positions.
Zero Point
Park Point and
Measurement Point
There is a small bar under the icon-bar which could show the momentary coordinates X,Y,Z