22621
General Mach Discussion / Re: Inverting display toolpath screen
« on: July 19, 2008, 09:53:30 PM »
not really
what I am saying is X0 Y0 should always be lower left of the screen, if you have your home switches set so that your home position is upper right then you want to set a Home Off amount in the homing and limits page for each axis. The distance you want to put in is the travel of your axis. That way when you do a home move the zero position will be lower left but your DRO will show up that you are at the opposite end of your travel.
Hood
what I am saying is X0 Y0 should always be lower left of the screen, if you have your home switches set so that your home position is upper right then you want to set a Home Off amount in the homing and limits page for each axis. The distance you want to put in is the travel of your axis. That way when you do a home move the zero position will be lower left but your DRO will show up that you are at the opposite end of your travel.
Hood