17121
General Mach Discussion / Re: verifyaxis macro only moves z-axis
« on: December 24, 2009, 06:40:37 PM »
I seem to recall there was a problem with the verify a while back, are you using an older version?
However saying that I dont know if it works properly in the latest versions because all my machines use the SmoothStepper and I dont think it works with it but even if it did as far as my mach is concerned my machines dont have home switches. I do the homing in the servo drives.
Hood
However saying that I dont know if it works properly in the latest versions because all my machines use the SmoothStepper and I dont think it works with it but even if it did as far as my mach is concerned my machines dont have home switches. I do the homing in the servo drives.
Hood