Messages

1

Mach4 General Discussion / New people welcome !! Come in here and introduce your self!

« on: November 23, 2017, 12:56:59 PM »

Hello all. Vern here and new to TapaTalk but successfully built a 3 axis mill a few years back and I'm evaluating Mach3 I'm needing some help and ran across this forum. Hopefully I can find some answers and provide someone with help as well. Here's my setup. Just upgraded the gantry with new motors, breakout board, microstepping controllers. Was using Editasc CAM software but it comes out of Germany and tech support is hard to get with the time difference and things get lost in the translation from German to English and I only speak hillbilly