Hi
The Machine is Cincom Citizen L20.
I will use one PC with Mach4 for the X1 Y1 Z1 C1 axes, end one PC for X2 Z2 C2, which is ok so far, but I need an output for the live tool servomotor, for which I will have to use an analog output.
The problem with the analog outputs on the UC300ETH controller is that they are given by some variables 114 and 115.
If at analog output 1 I check the PWM box, it deactivates my variable 114 and activates the output when the spindle start code (M3S ....) is given, outputs between 0V and 10V depending on the S command.
Even if I use the OB1 axis for the main spindle and use the selected pins for that axis, but I leave the PWM box selected, on the analog output1 I still have the voltage given by the S command (Ex. If M3S5000 - analog output = 5V)
If I deselect the PWM box on the analog output 1 I have no voltage on the output, but the variable 114 becomes active.
I can go with the unchecked PWM box, but how can I use any of the analog outputs of the board, I don't know how I can control the output through the variable.
I hope I've explained well enough that you can get an idea of what I need !