Messages

781

General Mach Discussion / Re: 4th axis issue (newbie)

« on: November 15, 2019, 06:59:52 PM »

You need to post some screen shots of your settings, 4th should move independant of any other axis, you may have it slaved to X by mistake.

782

Mach4 General Discussion / Re: Mach4 Hobby Screen Editor

« on: November 06, 2019, 07:07:32 PM »

Mach4 has to be in 'Disabled Mode' but the option should still be on the menu even if 'Enabled' but it will be greyed out

783

General Mach Discussion / Re: 4th axis issue (newbie)

« on: November 03, 2019, 09:02:41 PM »

Check the Ports and Pins, Motor Outputs under the Config menu and see if you have 4 axis configured and if yes then is it A,B or C that is ticked.

Once you know this you can go to MDI and type G00 G91 A90, B90 or C90 and the axis should move.

784

VB and the development of wizards / Re: Array G-Code Macro

« on: November 02, 2019, 07:59:57 PM »

Check out the G52 command.

785

VB and the development of wizards / Re: Saving VB-Scripts

« on: November 01, 2019, 07:48:57 PM »

Remove the script from the button and put it in the M6Start.M1S macro for your selected profile.

786

General Mach Discussion / Re: Cutting wrong dimensions in only one spot

« on: October 31, 2019, 10:40:29 AM »

That Gcode is producing the black line perfectly by the look of it.

787

Mach4 General Discussion / Re: Probe not matching with edge finder when measuring Y

« on: October 31, 2019, 09:59:35 AM »

place your setting ring at the farthest most point of the machine in X&Y from the home position, this on most machines is the least used place so is the lease worm part of the screw and slides. calibrate there and then edge find there.

If you find the same errors then its time for a new machine.  End of problem.

788

Mach4 General Discussion / Re: Probe not matching with edge finder when measuring Y

« on: October 31, 2019, 06:46:29 AM »

You could always have the machine laser aligned and mapped but the backlash is your main issue, to maintain the accuracy you think you need your machine mechanics need to be a power of 10 better, so you are not going to get it.

 

789

Mach4 General Discussion / Re: Probe not matching with edge finder when measuring Y

« on: October 30, 2019, 08:58:13 PM »

Is the error reversed if you probe the opposite face?

Also is there an error in the other axis?

Have you another gauge ring you can measure, the other may be oval

790

General Mach Discussion / Re: Mach3-The machine stop in execut program

« on: October 30, 2019, 08:46:20 PM »

If you are using the Licence that came with the board then it will always fail to work.