21351
General Mach Discussion / Re: To Ramp, Or Not To Ramp. That Is the Question.... And Others...
« on: October 17, 2008, 04:32:24 PM »
Ed, yes standard twist drills can be a real pain, on a drill press or a manual lathe you just stop feeding for a fraction then start again and that breaks the chip. Pecking does exactly the same but it can take a few goes before you get the depth of peck just right. I am starting to use U Drills now and they are the dogs dangly bits, thank goodness for eBay or I wouldnt be able to afford them.
Hood
Hood