19391
General Mach Discussion / Re: how to go to z without traveling dagonally
« on: April 26, 2009, 04:06:28 AM »
As far as I know you cant make the A run continuously unless you dont want to have any other axis move.
You can use Swap Axis and have the spinlde and A swap and thus any S commands would go out to the A Axis pins, you could then have a VB button that does the swap axis, or of course a macro called from code to do the same.
Hood
You can use Swap Axis and have the spinlde and A swap and thus any S commands would go out to the A Axis pins, you could then have a VB button that does the swap axis, or of course a macro called from code to do the same.
Hood