4991
General Mach Discussion / Re: New PC Loosing Steps (I think)
« on: May 31, 2010, 06:23:58 PM »
On my old Dell, Mach3 will NOT run smoothly unless set to Standard PC. That very well could be the problem.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Well, I wish I knew that before I bought my PC.
Of course, with the missleading information in the misslabeled "minumum requirements" section of the ArtSoft home page, how was I to know that "32 bit version" is actually a maximum unlike the other things listed like Ghz and RAM that are truly minimums.
If I only knew then what I knew now...........