1
General Mach Discussion / Installing two PCI Cards Address Question
« on: June 30, 2016, 12:52:00 PM »
Very new to Mach3 but I have been running my CNC Wood router with a DOS program and LPT Indexer for 20 years. I'm upgrading to an XP with Mach3 and I want to try to get this right the first time. I am preparing to install two new PCI Multi I/O cards. They are Syba SD-PCI-1P. I assume windows will automatically assign addresses but these cards support re-mapping to Legacy addresses. I want to make sure they end up with addresses that Mach3 wants to see. Should I install them one at a time and remap each one?